Applications Closets, wardrobes, service closets, hatches, access panels.
For 35mm (1 3/8") door panels to 2400mm (8' 0")
Testing 300.000 cycles on a door of 50Kg (100 pounds)
Advantages Low cost easy to fit pivot sets.
Simple hand tool installation.
Limited trade skills required.
No door frames (door jambs are not required).
No architraves or other casework trim.
No protruding hinge knuckles.
Materials Plates & Angles - 6063 aluminium T6 temper
Alum. finish - Etch prime (grey paint)
Bushes - Polyamide 6 lubricated during assembly
Pivot Pin - Steel (zinc passivated) brass available on request
Screws - Steel 4.5mm dia. CS zinc plated
Boxed Set Two non-handed pivot hinges (for one door leaf)
Fixing screws & metric fitting instructions
Notes Accurate plumb gypsum plasterboard work must be specified.
Pivot doors reduce the clear opening width.
Pivot doors, flush in walls, only open about 160°.
Always draw the swing of the door to check the arrangement.
The pivot stile of the door swings into the closet about 53mm (2").
No comments:
Post a Comment